Anyone know of a thread or write up on creating and installing a full snorkel system made from ABS or PVC pipe? I've seen the cowl snorkel, but am looking to route it out the fender and up the driver side A pillar.

 

Use steel! $60 and it is way better.

 

great looking rig

 

Thanks my $ into it is still under 3,000. lol

 

jeeze. i got just over that but i also have my system included in it.

 

Why? It's just heavier and more expensive

 

but 5x easier to work with depending on who you are. Would be for me.

 

What size tires and lift is that?

 

I figured out what I'm goin to do. Pics soon to come...

 

Since I have had it it has rubbed up on way to meany trees and rocks to count and I have only had it a few months. If it wasn't out of steel it would have broke. And it catches a lot of branches. I personally think it looks much better then any other homemade one I have seen. And the filter dose not sit out in the open to get caked with mud and water. I don't understand that design at all.
I run 36's with a 5.5" and I did a little wheeling and dealing to keep the cost down. The xj it's self was only 500 it was in a crash. Never meant to build it. Was a vary nice rust free dd but when tires and lift are cheaper then stock tires. Well things grow.

 

Hey Brutal, For Home made snorkels, I like the look of yours. Can you do a write up on the build of your steel snorkel? Thanks.

 

Does anyone have a pic of a cowl Snorkel off the Throttle body that uses a skinny cone in the passenger side cowl. I know I have seen before but I can not find. I have ABS and would like to try this setup.