Bad Camber after ZJ Tie Bar Swap
#1
Newbie
Thread Starter
Join Date: Sep 2013
Location: Warrenton, VA
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0L
Bad Camber after ZJ Tie Bar Swap
So I just upgraded from my bent stock tie rod to the ZJ rod on my 1991 XJ. Before the swap I had no camber issues. Now whenever I move the rig even only about 20 feet the tires get some weird lean (both sides). It is only in the front end and if i jack up the axle the tires visibly correct themselves. I am running a 3 inch lift with stock control arms and 33 inch tires. Anybody have any ideas on what could be causing the issue?
#2
CF Veteran
Join Date: Feb 2010
Location: Oroville, CA
Posts: 12,367
Likes: 0
Received 19 Likes
on
18 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 with all of the noise and clatter
Excessive toe out will give the illusion of negative camber. But check the front end out and make sure the ball joints are ok.
#4
Newbie
Thread Starter
Join Date: Sep 2013
Location: Warrenton, VA
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0L
The toe is probably of but I don't think that's the only issue. When I jack the front end the tires slide across the ground probably half an inch to an inch. It is bad enough that anytime I move it I have to jack the front end and lower it to have the tires straight.
Thread
Thread Starter
Forum
Replies
Last Post
southfloridajeeps
Modified XJ Cherokee Tech
32
03-04-2023 01:10 PM
shelby5041
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
11-07-2015 01:22 AM
MajorCollateralDamage
Modified XJ Cherokee Tech
5
09-01-2015 11:00 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)