What did you do to your Cherokee today?
CF Veteran
Joined: Apr 2011
Posts: 14,553
Likes: 1
From: Carrollton, GA
Year: 1994
Model: Cherokee
Engine: Inline 6 4.0L High Output
I put some noodles on my cage, put the seats back in, cleaned it out a little, ordered 5 pt harnesses, and a new retractable CB radio mount.
Gonna wash it tomorrow and if the weather is nice start laying down lines for the chop.
Gonna wash it tomorrow and if the weather is nice start laying down lines for the chop.
Newbie
Joined: May 2014
Posts: 6
Likes: 0
Model: Cherokee
Today I installed a new water pump and did radiator flush. Replace distributor cap and rotor button and also new plugs and wires. The plugs were in bad condition from PO. Also did an oil change with mobile 1 10-40 and purolator oil filter. Running much better than when I got it!
Newbie
Joined: Sep 2012
Posts: 19
Likes: 0
Well I got the new 3.5" drop pitman arm in (didnt help my steering problem) still cant make a sharp right turn. 6* shims on the rear end (helped a little on the accel vibes) still have terrible sound when I let off the gas over 40 mph. Oh well, I was hoping to get the cheap fix for the time being but I guess a SYE is in my future. By the time I get Blue back to the same drivability as I had pre lift I could have bought my XJ again. :-(
CF Veteran
Joined: Aug 2012
Posts: 1,592
Likes: 0
From: oregon
Year: 1993
Model: Cherokee
Engine: 4.0 ho 99 intake ps pump 1" tb spacer 62mm bored tb eletric fans and more
Drain the chocolate milk out of my transmission and put new stuff in. did the once over on everything going to hit some trails tomorrow
Junior Member
Joined: Jan 2013
Posts: 63
Likes: 0
Well I got the new 3.5" drop pitman arm in (didnt help my steering problem) still cant make a sharp right turn. 6* shims on the rear end (helped a little on the accel vibes) still have terrible sound when I let off the gas over 40 mph. Oh well, I was hoping to get the cheap fix for the time being but I guess a SYE is in my future. By the time I get Blue back to the same drivability as I had pre lift I could have bought my XJ again. :-(
CF Veteran
Joined: Jan 2011
Posts: 11,176
Likes: 1
From: Ohio
Year: 1995
Model: Cherokee
Engine: 4.0
Well I got the new 3.5" drop pitman arm in (didnt help my steering problem) still cant make a sharp right turn. 6* shims on the rear end (helped a little on the accel vibes) still have terrible sound when I let off the gas over 40 mph. Oh well, I was hoping to get the cheap fix for the time being but I guess a SYE is in my future. By the time I get Blue back to the same drivability as I had pre lift I could have bought my XJ again. :-(
::CF Administrator::
Joined: Feb 2011
Posts: 14,479
Likes: 805
From: Blunt, South Dakota
Year: 97
Model: Cherokee (XJ)
Engine: 4.6 stroker
Went to pick a part and got a front DS for my SYE to be installed this week, and also got a replacement rear pinion yoke as the current one is damaged...SYE will be here on Wendsday so gives me time to clean 'em up, paint 'em and install new u-joints...
Member
Joined: Apr 2013
Posts: 107
Likes: 0
From: Middle Tennessee
Year: 1999
Model: Cherokee
Engine: 4.0
Got the light bar on as well. No gotta get the lights installed (next weekend)
It's a monstrous bumper! Thumbs up!
Seasoned Member
Joined: May 2011
Posts: 370
Likes: 2
From: Calgary, AB
Year: 99
Model: Cherokee
Engine: 4.0
Fixed sagging drivers door. Bought a pair of the doorman hinge pins (99) also reattached a broken rear window wire while I was in there and put the door stop check thingy in. The old hinge pins are a real b**** to get out.
But it's done.
But it's done.