Hahaha! I see what you did there.. For a second I was goin wtf???

Yeah, wanted lighter than the 15-40, so I went with 10-30, but of course, it was the diesel variety. =\

 

Yes, I run rotella 15/40 most of the year. Switch to rotella 5/40 around end of Nov till March. Only oil I have ran that stays clean. Plus the valve train is sludge free now.

 

Went to the jy and pulled a front driveshaft so when my iron rock sye for the 242 gets here Monday I'll be ready to get rid of this tc drop finally.Also looked or ZJ tie rod but no V8's were there.

 

How much was the 242 kit?

 

 

I feel much better now.

 

For the hack n tap sye it was 99$,I also bought the drill bits and tap(19.99),and the jig(29.99) to hopefully make the install easier. Shipped 162$

 

That's what like half the forum runs dude... lol

 

Yeah.. I flashed some hardcore ignorance there. Haha.. That's me laughing at myself. The shameful crying I'll do later when I'm hanging out in the corner.

 

lrn2troll moar

 

Huh?

 

I didn't do this to my Cherokee, YET...but still wanted to share my excitement somewhere that I finally started welding after 8 years since the last time I did.



Don't judge! haha


"Serialwelderkiller" as she would put it lol


I now feel much more at ease and excited to fix my rust and do 2x6 rocker sliders! Need much more practice though.

 

Cool! Decent welds man. God I wish I had one..
And the space to keep it..

 

Wrong kind of trolling

Also gg on the ultra-low-res picture. That's not even legible.

 

Not bad!