Cherokee Chat General non-tech Cherokee chat
XJ/MJ/ZJ/WJ

Steering Question.....

Old Jul 6, 2012 | 01:41 PM
  #1  
Chris01XJ's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2010
Posts: 502
Likes: 0
From: Columbia, SC
Year: 2001
Model: Cherokee
Engine: 4.0 I6
Default Steering Question.....

Ok guys I have a steering issue. When I go to take a turn whether it be left or right.....it wants to fight back the opposite way like someone is tugging the steering wheel in the opposite direction but its not violent or hard by any means. I'm not low on power steering fluid and my pump isnt whining or making any noises. I was thinking it might be my SS but that is only a couple months old its a rough country big bore unit. Im at a loss.....
Reply
Old Jul 6, 2012 | 02:08 PM
  #2  
VTJeep's Avatar
CF Veteran
 
Joined: Jul 2010
Posts: 4,930
Likes: 3
From: 802
Year: 99
Model: Cherokee
Engine: 4.0
Default

Originally Posted by Chris01XJ
Ok guys I have a steering issue. When I go to take a turn whether it be left or right.....it wants to fight back the opposite way like someone is tugging the steering wheel in the opposite direction but its not violent or hard by any means. I'm not low on power steering fluid and my pump isnt whining or making any noises. I was thinking it might be my SS but that is only a couple months old its a rough country big bore unit. Im at a loss.....
Confused!
Can you clarify a coupe things? What's SS and what's a RC big bore unit? You just mean that your runnin RC shocks, right?

Id say top the fluid off for sure. How is alignment and front end in general. What size tires/lift ya got?
Reply
Old Jul 6, 2012 | 02:36 PM
  #3  
jbsjunk's Avatar
CF Veteran
 
Joined: Oct 2011
Posts: 1,630
Likes: 3
From: Hudsonville, MI
Year: 1986
Model: Cherokee
Engine: 5.0
Default

Also check for a binding axle joint, those can cause these problems.
Reply
Old Jul 6, 2012 | 02:47 PM
  #4  
Chris01XJ's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2010
Posts: 502
Likes: 0
From: Columbia, SC
Year: 2001
Model: Cherokee
Engine: 4.0 I6
Default

Originally Posted by VTJeep
Confused!
Can you clarify a coupe things? What's SS and what's a RC big bore unit? You just mean that your runnin RC shocks, right?

Id say top the fluid off for sure. How is alignment and front end in general. What size tires/lift ya got?
Rough Country steering stabilizer (SS). Fluid is good no need to top it off. Just had an alignment done about a month and a half ago. 32/11.50's on 4.5" lift. hasnt been offroad in almost a year so It hasnt been knocked around.
Reply
Old Jul 6, 2012 | 02:49 PM
  #5  
Chris01XJ's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2010
Posts: 502
Likes: 0
From: Columbia, SC
Year: 2001
Model: Cherokee
Engine: 4.0 I6
Default

Originally Posted by jbsjunk
Also check for a binding axle joint, those can cause these problems.
How would I check to see if its binding?
Reply
Old Jul 6, 2012 | 02:58 PM
  #6  
VTJeep's Avatar
CF Veteran
 
Joined: Jul 2010
Posts: 4,930
Likes: 3
From: 802
Year: 99
Model: Cherokee
Engine: 4.0
Default

An axle joint? You mean the front DS which has a cv joint, right? Just makin sure Either way- jeep in N, ebreak on, crawl under and see if you can wiggle the shaft around or I there is any play in it at all.. Do the same to the rear DS while your there.

Also try getting a wheel jacked up a few inches and slide a pry bar under it and see if you can get the wheel to clunk. If it does, it's a bad u joint.
Reply
Old Jul 6, 2012 | 03:15 PM
  #7  
jbsjunk's Avatar
CF Veteran
 
Joined: Oct 2011
Posts: 1,630
Likes: 3
From: Hudsonville, MI
Year: 1986
Model: Cherokee
Engine: 5.0
Default

Axle joint, the one at the wheel. Turn the steering wheel full lock to either side and turn the tires to feel if it binds, if it does, the axle joint is bad.
Reply
Old Jul 6, 2012 | 03:56 PM
  #8  
Chris01XJ's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2010
Posts: 502
Likes: 0
From: Columbia, SC
Year: 2001
Model: Cherokee
Engine: 4.0 I6
Default

Originally Posted by VTJeep
An axle joint? You mean the front DS which has a cv joint, right? Just makin sure Either way- jeep in N, ebreak on, crawl under and see if you can wiggle the shaft around or I there is any play in it at all.. Do the same to the rear DS while your there.

Also try getting a wheel jacked up a few inches and slide a pry bar under it and see if you can get the wheel to clunk. If it does, it's a bad u joint.
I do have a bad pinion seal on my D30 therefore the pinion bearing might be bad. My front DS does have play in it maybe a half inch.
Reply
Old Jul 6, 2012 | 03:57 PM
  #9  
Chris01XJ's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2010
Posts: 502
Likes: 0
From: Columbia, SC
Year: 2001
Model: Cherokee
Engine: 4.0 I6
Default

Originally Posted by jbsjunk
Axle joint, the one at the wheel. Turn the steering wheel full lock to either side and turn the tires to feel if it binds, if it does, the axle joint is bad.
Should it be off the ground when checking this?
Reply
Old Jul 6, 2012 | 05:57 PM
  #10  
VTJeep's Avatar
CF Veteran
 
Joined: Jul 2010
Posts: 4,930
Likes: 3
From: 802
Year: 99
Model: Cherokee
Engine: 4.0
Default

You can take a little pressure off the tires with a jack, but sitting solid on the ground will offer more resistance and probably tell you more.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ROCKRIDGE 4WD
Vendor Showcase
1
Dec 22, 2018 09:49 AM
The Aristocrat
Wanted
2
Feb 25, 2017 01:17 AM
1998CherokeeXJ
Modified XJ Cherokee Tech
20
Nov 21, 2015 07:49 AM
gyrator930
Modified XJ Cherokee Tech
4
Oct 1, 2015 08:31 PM
kend3031
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
1
Sep 30, 2015 08:15 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 09:08 PM.