CheifRupp

Anyone have the dimension i need to make my bumper mounts and how far wide i should put em on the bumper to line up with frame, thanks

ChileRedBateman

make these

or buy them... http://www.ajsoffroadarmor.com/produ...cat=256&page=1 bolt them up with a few bolts each, then build your bumper off of them, then they'll be right where they need to be.


like this fellow did: https://www.cherokeeforum.com/f58/my...-bumper-70232/

ChileRedBateman

oh btw this was posted in wrong spot... If you are asking something it goes in tech section, please only start posts here if you have started building something...

@Moderators You should put a LARGE BOLD print message in the FAB section stating the above.

Jeep450r

^^ Have you actually used those dimensions? If you did (and if they actually were correct), that would be very helpful for my next bumper build haha

no rdplz

Outside of the unibody frame rails are 33" apart on our xj's

Dan91

http://www.twisted-halo.com/digicam/...er%20mount.pdf
Confirmed working by many different year XJ owners...however i'd advise making a cardboard template and checking first.

ChileRedBateman

THANK YOU! that was the one i WAS looking for, I was posting the picture as more of a "do it like this" then actual spot on measurement, AND yes always do it with cardboard/cereal box first...

jhatala

thanks for the link! Anyone know the size of the holes?

Dan91

Just decide what size bolts you're gonna use then go from there.

Cherokee.Dreamer

so on that diagram im assuming that when it gives the numbers like 17.000 that measurement is in inches correct?