Replacing heater core. Does any one know where to find the foam (or pads) that go under the evap and around heater core?? I've searched everywhere called multiple places and even checked the Jeep Dealership parts catalog! Nothing!!!!! UUGGGHHH.
Please help!!!
Thanks,
Ash

 

https://www.morris4x4center.com/seal...4874069ab.html
https://www.ebay.com/sch/sis.html?_i...75.m4099.l9146

 

Start reading from Post # 26. This guy used aftermarket stuff. Might give you a little insight.

http://www.naxja.org/forum/showthrea...1144935&page=2

 

 

I decided to make my own, and its been working great for months. I used case club closed cell foam from amazon to do the inlet/outlet hoses to firewall seal, just modeled it after the old one and cut it out. If you are careful, you can save the one around the blower motor and with some rtv it's good as new. The foam under the evap is harder to make. I tried it and ended up just leaving it out since I could see no real function to it.