That is So Bad *****! Once I show my buddy he's going to do that for sure.

 

Yep I did the same thing except with the super white leds.

 

Awesome thread.

 

here are my home made disco's made with a 1/2" clevis pin on the bottom and 7/16? wing nuts and lock washers. they work awesome then i use a 2' piece of velcro to hold up the sway bar so its not flopping around

 

Nice, how much was that wing nut 4 bucks at least.... isn't 1/2 clevis pin a little loose in the sway bar bushing? Good idea though, hate to see people blow over a hundred dollers on discos... Did you spray paint your bumpstop red? intresting.

 

not $4 they were $1.39 at ace. the pin is a little loose but not bad to were it would break because of it. i used some washers in there also to tighten it up. i didnt paint my bumpstop it was like that when i bought it. its all scratched and stuff cuz i used a 2lb sledge to get my spacer in and missed a couple times lol.

 

what about the LEDs in the cupholder? thats what i wanna know

 

sweeeeeeeet thread.

 

This shows how i did it.



This is where you tap in too.



These are the LED's I used. I used 3mm LED's

http://www.oznium.com/prewired-leds

 

ok just ordered them.... what size is the hole? and how to they stay put?

 

I got a 1/8" drill bit. Drilled the hole. Then I put a medium wendys cup in mine. Which fits really tight in the holder. I then placed a piece of tape on the cup where the hole was (so the super glue won't peal the paper off the cup). I then held the LED's in place and super glued them in.

 

ok thank so much! ill post it up when done!

 

nice little ipod holder, help up with some bread bag ties

 

Remove factory switches and installed homemade panel.. And two gauges

 

this is gonna take a while....
front bumper

rear bumper

long arms


adjustable bumpstops

tracbar, tracbar axle mount, tracbar frame mount brace


spare tire mount

shock adapters

rock rails

half doors

hi-lift mount