Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here! ZJ (93-98), WJ (99-04), WK (05+)
All ZJ/WJ/WK specific tech questions asked here!

94 GC Inline 6 - Fuel/cool/cold weather issue

Old Oct 19, 2015 | 01:32 PM
  #1  
SpitFire's Avatar
Thread Starter
Member
 
Joined: Aug 2009
Posts: 139
Likes: 0
From: Wheatfield,Indiana
Year: 1994
Model: Grand Cherokee
Engine: 4.0L MFI 6cyl
Default 94 GC Inline 6 - Fuel/cool/cold weather issue

The last month or so I've been having issues with the fuel pump (I think). When ever the temp outside gets to 50 degrees or below the Jeep will not start right away.

As I turn the key I DO NOT hear the fuel pump kick on. It takes a few tries and then I hear it turn on and clicking noises near the area of the Computer. I checked the relay and it seems to be ok. Changed the fuel filter and all of the ignition system has been replaced (other issues dealing with the crankshaft sensor)

In nice weather, the jeep starts before I even let off the key and runs smooth. When I get it started in cold weather. I have no issues starting it again after it warms up.

My guess is the fuel pump may be going out or moister somewhere. Any help would be great.
Reply
Old Oct 19, 2015 | 02:03 PM
  #2  
dave1123's Avatar
Old fart with a wrench
 
Joined: Nov 2010
Posts: 14,398
Likes: 741
From: Manlius, east of Syracuse, NY
Year: 2000 XJ Sport & WJ Laredo
Model: Grand Cherokee (WJ)
Engine: 4.0L
Default

This may help or cause you to do a lot of searching. Over the years, I've found that sometimes the female parts of connectors tend to loosen up or deform and lose their grip on the male portions of the connector pins, especially in high amperage circuits. This only happens once in a while, but today they are using thinner metal in the plugs and this has become more prevalent. I've noticed GM always used round male pins, but I've noticed Mopar uses square pins and this might have something to do with it.

I have a problem with my left turn signal and only the left one. I've replaced the switch and that hasn't helped. I'm going to have to disconnect the plug and tweak the connectors to see if this is the problem. It only does it where it's cold. I can turn on the left signal and then turn on the hazard flashers, then turn them off as soon as they light up, then the left signal will continue to work until the jeep cools down again. This gets confusing to other traffic if I'm sitting in the middle of an intersection trying to make a left turn. AND it's getting worse!

I'd say start with the plug on your fuel pump.
Reply
Old Oct 19, 2015 | 02:19 PM
  #3  
SpitFire's Avatar
Thread Starter
Member
 
Joined: Aug 2009
Posts: 139
Likes: 0
From: Wheatfield,Indiana
Year: 1994
Model: Grand Cherokee
Engine: 4.0L MFI 6cyl
Default

Originally Posted by dave1123
This may help or cause you to do a lot of searching. Over the years, I've found that sometimes the female parts of connectors tend to loosen up or deform and lose their grip on the male portions of the connector pins, especially in high amperage circuits. This only happens once in a while, but today they are using thinner metal in the plugs and this has become more prevalent. I've noticed GM always used round male pins, but I've noticed Mopar uses square pins and this might have something to do with it.

I have a problem with my left turn signal and only the left one. I've replaced the switch and that hasn't helped. I'm going to have to disconnect the plug and tweak the connectors to see if this is the problem. It only does it where it's cold. I can turn on the left signal and then turn on the hazard flashers, then turn them off as soon as they light up, then the left signal will continue to work until the jeep cools down again. This gets confusing to other traffic if I'm sitting in the middle of an intersection trying to make a left turn. AND it's getting worse!

I'd say start with the plug on your fuel pump.
I'm to pick up a new relay switch in the morning after work. I swapped relays, but that was only after I already got it started =/ I honestly didn't even think of the plug on the fuel pump. Luckily I got my 40 hours back at work and can afford a new fuel pump if worse comes to worse. I'll give it a shot, Thanks Dave
Reply
Old Oct 29, 2015 | 04:17 AM
  #4  
SpitFire's Avatar
Thread Starter
Member
 
Joined: Aug 2009
Posts: 139
Likes: 0
From: Wheatfield,Indiana
Year: 1994
Model: Grand Cherokee
Engine: 4.0L MFI 6cyl
Default

(Update)

I was searching google for the Neutral safety switch and happened upon this thread https://www.cherokeeforum.com/f5/fue...-4-0-a-181935/

I am having identical issues. Before I leave from work. I am going to see if allowing the caps to warm up allows the Jeep to start normally. I have all the stuff to fix the ECM if it ends up being bad caps. Wouldn't that be nice!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
4WD4EVER
Modified XJ Cherokee Tech
28
Jul 28, 2023 07:12 PM
91cherokeeSC
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
41
Oct 29, 2015 01:49 PM
AFbrat
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
16
Sep 29, 2015 09:08 PM
Bearstream
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
Sep 28, 2015 10:53 AM
little smathers
Modified XJ Cherokee Tech
0
Sep 20, 2015 03:32 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:24 PM.