Homemade Bar Pin eliminators using the rear swaybar mounts
They and about and inch to the shock length

 

I tool the bar pins out, cut the ends off and drilled them out to half inch.....then I pressed them in the shock and used a half inch bolt to go through the bar pin eliminator

 

Now the Dana 44 has a new home

 

Rear lift complete.....I threw the stock 235/75-15 tires back on to make it easier to lift the front off the ground to install the front lift....kinda a bad angle i will post another pic when i get a chance

 

Its raining today...... I wont make any progress

 

Ok Got the front part of the lift on 3" Rough springs and 2" spacers

 

Coil and spacer

 

Hockey puck Bumpstops

 

Brake line Relocation

 

Ok the tie rod was frozen and could not be adjusted to align the front end I tried everything Torch...penetrating spray .......brut force....nothing worked ....so I went to pull a part and got one off a grand cherokee that looks almost new for $7 and final got the front end aliened....Pic of bad tie rod

 

Rubicon Express Lower Control Arms .....I also have some JKS bar pin eliminators on the way ....not installed in this pic

 

New adjustable Track Bar

 

Finished and tested.......