Jeep Buildup Round 2!
#47
Seasoned Member
Thread Starter
Join Date: Sep 2010
Location: Mitchell Co. NC.
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: big 6
Yes i got it taken care of for the most part. My pitman arm was loose which was most of it. Next i replaced the ball joint or endlink or what ever its called on the end of my steering arm. Then there was a few other odds and ends that needed tighening or replacing but That got the most of it. i still need an alignment before winter. Im pretty sure it has a 5.5 rough country lift on it and as far as trimming goes it needs it lol. I really dont want to cut the fenders and roll the backs because the PO painted the flairs and didnt tape them well so you would see i line where they were. Its probably going to happen eventually though
#48
Seasoned Member
Thread Starter
Join Date: Sep 2010
Location: Mitchell Co. NC.
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: big 6
finally got my rear bumper going!! still not done i have to make my ends but im waiting on metal at the moment
I also added a roof rack!
Then i added my Lifting lugs that i sell on my bumpers
Not bad for a 110 welder (Hobart Handler 140)
Next came my receiver
I also added a roof rack!
Then i added my Lifting lugs that i sell on my bumpers
Not bad for a 110 welder (Hobart Handler 140)
Next came my receiver
#49
Seasoned Member
Thread Starter
Join Date: Sep 2010
Location: Mitchell Co. NC.
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: big 6
this will give you a good idea of the angle on everything
Eat your heart out 220.. i can do this **** in my bathroom!
then i boxed in my ends and put some paint on till the rest of my steel gets here.
You can see the rack in the next few pics
#50
Seasoned Member
Thread Starter
Join Date: Sep 2010
Location: Mitchell Co. NC.
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: big 6
this is what my rack started out as. ill get more pics of that process up later..
Thanks for looking!
Thanks for looking!
#52
Seasoned Member
Thread Starter
Join Date: Sep 2010
Location: Mitchell Co. NC.
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: big 6
Thanks dude, im looking forward to getting it done. Ive got to get some 2x2x3/16ths box tube to finish the ends. Ive got a pretty good idea thats a little different from how most do theirs. Hopefully everyone will like it. I also have to do a little more body trimming so i can get my reciever hitch pin in
Thread
Thread Starter
Forum
Replies
Last Post
StPTrucker
Introductions
30
11-22-2015 05:07 PM
madmanmarty
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
30
08-30-2015 03:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)