Haha. I figure I'd never have to upgrade again

Yeah, I'd say that's a safe bet. lol... being as it will weld from 18ga to 1/2" hahaha... if you need anything bigger than that well, you'll have one heavy-*** Jeep!

Haha true, but it wouldn't be for just the Jeep.

Here's the quarter panel cut and fold write-up
https://www.cherokeeforum.com/f51/rusty-quarter-panel-cut-fold-228882/

'nother goodun

Thanks! I'll be doing one for the rear fender trimming also.

Got the rear drivers side fender trimmed up and brought the fronts up to match the other weekend.






Last night I got my rear bumper design figured out. I'm hoping to get it built next weekend.

Here's the write-up on the rear fender trimming.
https://www.cherokeeforum.com/f24/re...t-weld-229141/

Looks good bud,, Ive been lurking lol

Thanks!

Nice! Did you extend the bumpstops too?

Thanks. Not yet, I still need to measure for them.

Right on.

It says I don't have permission to view this page. What gives?

It should work now.