91 2dr in the works
Thread Starter
CF Veteran

Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
Oh and for anyone looking for extended brake lines....these Rugged Ridge lines were only 66 shipped to my door from Amazon. Can't beat that for front and rear extended lines.
Thread Starter
CF Veteran

Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
Damn. These lines are nice.
So I started on the install of the 3 link today. Got both brackets mounted with the crush sleeves welded in. Then mother nature decided it was time for me to stop. I stopped for a little and then it lightened back up just long enough for me to get the front wheels off and the whole front end supported. Only carnage today was to my pinky. Slipped off a wrench and straight into the LCA mount. Who knew bones were so white?
Got that bandaged up and called it quits. Tomorrow I should have some helping hands so it should get finished...keeping fingers crossed. Only thing left is to cut off lca mounts, install flex joint at axle uca mount and bolt up arms.
Will post up pics tomorrow of the work.
So I started on the install of the 3 link today. Got both brackets mounted with the crush sleeves welded in. Then mother nature decided it was time for me to stop. I stopped for a little and then it lightened back up just long enough for me to get the front wheels off and the whole front end supported. Only carnage today was to my pinky. Slipped off a wrench and straight into the LCA mount. Who knew bones were so white?
Got that bandaged up and called it quits. Tomorrow I should have some helping hands so it should get finished...keeping fingers crossed. Only thing left is to cut off lca mounts, install flex joint at axle uca mount and bolt up arms.
Will post up pics tomorrow of the work.
Thread Starter
CF Veteran

Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
Well didn't get it done today. worked from 11 to 4:30. Got the old LCA and factory UCA off. Then tackled the painstaking process of cutting off the LCA mounts. Took 4 hours to do it and even left part on the frame since its not in the way. Went through 10 cut off disks and burned up one of my grinders.
Ok since you probably didn't read that above, here's what it says in pics lol
Ok since you probably didn't read that above, here's what it says in pics lol
Thread Starter
CF Veteran

Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
Thread Starter
CF Veteran

Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
Well the brakes are bleed and she's on her own feet again. Rides pretty good. I do have some vibration transmitting through the floor because the UCA bolt contacts the floor board. I'll find a shorter one and swap it out. Then shell be perfectly smooth down the road
Seasoned Member
Joined: Dec 2010
Posts: 402
Likes: 2
From: Charlotte/Raleigh, NC
Year: 1999
Model: Cherokee
Engine: 4.0 MPI




