It's currently sitting in my back seat... So no lol.
The window was higher on priority list, so I did end up getting the new one de-tinted, cleaned, and put in though

 

Haha yep it's getting there. And it's a Vette actually.

 

i replaced my ball joints today uppers and lowers

 

Well havnt done anything yet but did pick up a hp dana 44 from a f150 to narrow and swap into the Jeep in the future. And now I'm gunna start my 1 ton cross over steering install on the dana 30 that's in there right now.

 

^^^^^^

Very nice

 

fixed hood, replaced hood release cable, released the hinge (frozen and bent) changed over mags to 1990 Jeep, did alot of little things, can't remember all what all I did. LOL, kind of a blur

 

Washed it up and made it all shiny lol.

 

Started and finished up the install of my new crossover 1 ton steering setup. Along with new ball joints

 

Stretched its legs

 

Replaced a bad orielys alternator and replaced my pos battery.

 

Is anyone still on? I have a problem.... The radiator I got, even though it's out of an identical jeep, doesn't have tranny cooler hose fittings.... And I didn't realize this until I had everything ripped out.

Is there a cheap way to make one, or how much is it at orielly's or something... I have to drive back home tomorrow

 

Doesnt your old one have the fittings?

 

Yes but I really don't want to put it back in. It got taken out because it leaks too much. How hard is it to install tranny coolers?

And saying the radiator doesn't have the cooler inside it, sorry

 

Trans coolers are easy to install. Just lop the ends of your trans cooler lines off and use rubber hose to plumb to the cooler. Make sure to double hose clamp it, though.

 

Where's the best location?