Changed her oil with some valvoline and a MOPAR filter (to replace that cheap fram that was there) then I sealed up the seams in my new floor with some duct sealer (awesome stuff). Also got my passenger and back seats mounted to the new floor, Then I went on to find I had a bad left rear wheel cylinder and it was leaving puddles. So I scavenged a cylinder and shoes off another rear end I had. Oh, and I cleaned all the useless cr@p and garbage out of her. Productive day, now I'm on to rebuilding the 29 spline 8.25 to swap in, getting a powertrax no-slip for that. Next project is rebuilding my spare 231 with an SYE and starting the lift.

 

Installed my shifter for my klune case which involved cutting a hole in the floor. Then I modified my center console and made a mounting bracket to bolt in my dana 300 cable shifter mount. Woohoo I I just have to attach the cables now and I will be able to shift my transfercase.

 

Been using my jeep to tow the chipper around, today I got a little carried away
Flopped it back over and ran it all day lol.

 

finished the longarms,added some hella 700 lights,and got the sye installed now just waiting for the tom wood drive shaft to get here.

 

Just finished my first ax15 rebuild... If it moves my XJ then ill rebuild my spair (fingers crossed)

 

Put in a new spot on the hood



Before I wired it

 

Bought a filter and some tubing to make myself an intake in the hopes of keeping my mpg's out of the single digits.

 

Out with the old in with the new

 

Good luck lol, I have seen double in a while Haha. Let us know how it works

 

Damn hammer broke my T case housing I had nothing to do with it

 

Nice shaft! They must have changed the design a little since i got mine from them. Mine looks like they pulled a front xj shaft and mailed it to me lol. no fancy boot lol

 

He said "nice shaft".

 

Bwahahaha!

 

I scored a full set of 5 American Racing "Gambler" wheels for $100

 

Just picked up a full float Dana 60 rear for 100$