Rebuilt my t case and installed the rebuilt tranny, everything moves like it should! Not bad for a first time rebuild on both.

 

Made my intake and its almost done but i was a little destructive under the hood. Sounds good though.

 

I stared at my new LCA's and control arm drop brackets and thought about installing them...

maybe tomorrow...

 

Started my BDS 4.5" short arm lift. Got the back done and most of the front, finishing it up tomorrow...now time for new tires, my 31"s look small.

 

Looks good! What size tires are you getting?

 

Guess ill need bigger tires when I lift mine to 4.5 lol looks good though.

 

Planning on 33"x10.5" BFG all-terrains. I could fit 35"s, but that's gonna wait until I get some 4.10 gears in it. After all, it's my DD lol.

 

Just got home from some late night wheeling, smashed the axle pretty good off a beast of a rock. The front end would not stop whining all the way home, guess I'll see what carnage there is in the a.m.

 

Threw some swaybars away and tweaked on my intake.

 

Installed a boot on my d300 transfercase double shifters to make it water tight. Then I hooked up the cables going from the transfer case to the shifters finally. I went out and tested it and the d300 shifts perfectly. Now after working on installing my dang d300/klune V crawlbox setup for the last few months I can finally say I am done!!!

 

All done! 4.5" SA, rear swaybar delete, front swaybar discos, Tcase drop for now, on 31s.

 

Got a new windshield put in.

 

Changed out my crossmember Saturday and I thought everything was going to fall on me! There was so much pressure from when the old one was bent, that when I unbolted one side it unloaded like a friggin spring. One problem lead to another.... Still working out some minor "kinks" in the system

 

That **** is scary to be underneath when taken the crossmember off. Lol

 

Diff fluid change and redid the paint from the po



Before



My arb ^-^



All done waiting for rtv to dry so I can put the fluid in