I took a look at the fluid and it is still like it was when I put it in the tranny with the change if filter and gasket.

 

Full shaft SYE replaces the main shaft. The 21/23 business is the input gear, which is separate. Otherwise you'd never get into 4LO

 

It was doing this problem before I changed any of the fluid or gasket or filter it was worse before all of this I couldn't drive it at all I literally had to limp it home that time and now it still try's to drive just slips out and acts like it is in neutral

 

Hey im looking to put a 95 transfercase into a 97 but the spedometer is different.. one mechanical and ones electrical.. any idea how to solve this? I dont wanna have to switch my cluster or anythimg like that

 

I got an 88 xj after the po had jousted with a rock wall . Wasn't sure if the front axle [d30] was bent so i found a good deal on cl I think out of a 92, complete except the rotors and calipers. Anyway long story short the calipers and rotors i have off the 88 don't seem to fit.I've lost my chilton book but the hardware I marked and bagged off the 88 does not seem to cross over. Is this just the jeep gods way of telling me to go with the wj upgrade or do I just need the older xj knuckles Thanks Gary

 

Swap them... the hole in the tail housing should be the same.

 

I'd just buy new calipers and rotors for a '92 and your hardware as a core

 

The one in question is the one labeled vac fitting with no hose going to it in the diagram. Thanks Cruiser.....

 

Federal or California emissions? (How many catalytic converters and O2 sensors?)

 

I took a look at the fluid and it is still like it was when I put it in the tranny with the change if filter and gasket.
It was doing this problem before I changed any of the fluid or gasket or filter it was worse before all of this I couldn't drive it at all I literally had to limp it home that time and now it still try's to drive just slips out and acts like it is in neutral

 

Sounds like you need a new transmission.

 

Wondering about how much 2 door doors weigh...

 

Is there nothing I can do to get the tranny to work with out rebuilding it?

 

If its dead its dead. Find a good used one.

 

Is their a upgraded electrical system I can install. I have a AMC 87 2door Cherokee Laredo and I also have a 89 Comanche with electrical problems...lookin for like a conversion.