yep thats it, thanks man thats wat i needed to know

 

There is also all the tie rod conversion kits available but then its the cost.Try to find one at the JY thats already ben done.Pull the parts.

 

could i just recplace the ball jont?

 

and is this the part of the drag llink i need?
http://www.quadratec.com/products/56118_12.htm

 

No stock is all one piece.

 

Yeah thats the whole piece

 

do what?

 

ok, soo all i need is that and a tie rod end for the drivers side

 

Yes thats what you will need.

 

Check Napa if you have one locally they may be cheaper.

 

idk if we have a napa, im new in this town, we have an orileys, advances, and autozoe i think

 

Just make sure you get at least moog brand or something comperable to it.

 

yeah, i dont want to get a piece of crap one, thanks for all yalls help i appreciate it

 

All that is seperated on your existing end is the grease boot. With some channel lock pliers and a little patience, you can get that to snap back in place. There is a round metal clip inside the boot that snap over the edge to hold it in place. I did it on a ZJ tie rod i pulled from the jy. I tore the boots when removing it and replaced them with the boots from my tie rods I was replacing.

 

oh haha i got that pic from here somewhere thats not mine i just wanted show what end i was talkin bout but thatnks for the info i might need that someday