I am trying to put my lift on tomorrow and made an attempt at the RE adj. track bar. My question is do you have to drill the hole out to 5/8(bolt size) or am I missing something? I bought it used so dont have the directions. Also how do the misaliagnment caps go on? Thanks in advance for feedback.

 

Misalignment washers go on with the taper in toward the Hiem joint one each side. And yes you have to drill out the frame side bracket, and it's either 9/16's or 5/8's start with the small drill bit and than check if it still don't fit go to the next size. You do that so you don't end up with a over sized hole...

 

Sounds like a plan that is what I will do. Thanks for the help.

 

You will have to drill the hole on the frame mount end to 5/8.. If you need directions head over to rubiconexpress.com and you can snag the directions from there as well..

 

Click this link, then on the right side click the PDF. Those are the instructions.
http://www.rubiconexpress.com/Produc...=426C306951032

 

Thanks so much guys. The lift will be on tonite and I will try to post some pics. 32's dont go on til first week of Aug. but it will get done.

 

Looking forward to seeing the lift

 

I cant wait. I am hoping it wont take to long.

 

It will!! Good luck anyway!! Peace out!!

 

It took 5 hours with some breaks in between. I will post pics tomorrow after work. Now I just need the bigger tires.

 

Congratulations, looking forward to seeing the pics.

 

cant wait to see the pics...