I haven't been able to get a response or find a picture anywhere so...

 

It's a 98 cherokee by the way

 

get a plug from the junk yard and splice it in best bet

 

Sorry, I don't have a pict. But, instead of soldering the wires to the resister you can always fix it the way I did on a La Barron that I had. all I did was had some female blade connectors and put them on the wires then just plug those to the resister. That way if you need to change it out again you don't have to worry about getting the solder off next time. that is if you don't want to get the plug from the junk yard.

 

Yea I think I might try that. I'm just not sure which wires go where.

 

Let me see if I can find some thing for you. Give me a little bit to look.

 

look here match the colors...http://www.jeep4x4center.com/knowledge-base/index.htm

 

Lets see if this works. the last time i tried to post a pict it wouldn't work for me. This was the best I was able to find. Hope it helps.

 

http://www.ebay.com/itm/DORMAN-973-4...f8b367&vxp=mtrthink i found what ya need...

 

Well I have the resistor put in. I just don't know which wires go where. The plug for the wires that connects into the resistor got cut off and thrown away. I just need a picture of the wires going into the resistor under the glove box so I know where to connect each one.

 

this look like it

 

Yes! Is that the top or bottom? So I know which way to line them up.