Stupid question but does anyone have a picture of how the passenger coil is suppose to sit on its perch? It seems to be making a little noise after putting new coils in. The drivers side perch had an obvious divot as to where the coil should sit but I'm not exactly sure how to position the passenger.

Thanks
Zach

 

post pics of yours did you use adjustable trac bar or the relocatin bracket

 

yes. Double shear trac bar with the drop and long arms

 

Im asking which rotational position should the coil be in. Not up or down obviously ha

 

ok that helps its dark here been a while since i put my lift in cant remember and cant see right now did you center the axle before adjusting track bar

 

yeap. I don't think you understand my question. Think of when the weight of the jeep is off the axle and you loosen the retaining clip for the spring; at this point you are able to rotate the coil. I need to know in which position it needs to sit on the perch

 

there is a groove just like the driver side. well, there should be.

 

On my 98 the slot is in the back. Towards the axle you can't see it very good.