where can i source the jeep side of the oil sending unit plug? the harness side clip is broken so i get random oil pressure readings while i'm driving. the vibrations from driving cause the plug to slip out and give some crazy readings. any help?
Seasoned Member
zip tie the connector together, I've got a few like that.
or, not sure if this will work, but you can try an earlier model sending unit...I know 1990 and 91 use a simple blade connection, and 1995 uses some complicated automotive connector thats prone to breaking.
or, not sure if this will work, but you can try an earlier model sending unit...I know 1990 and 91 use a simple blade connection, and 1995 uses some complicated automotive connector thats prone to breaking.
Seasoned Member
If that does not work check this.
http://www.napaonline.com/Catalog/Ca...165_0334779096
http://www.napaonline.com/Catalog/Ca...165_0334779096
Seasoned Member
mine looks like two wires that are VERY tightly taped/shrinkwrapped together. should be two wires
ok. didn't look like two wires, but the plug is jacked. i'll have to look into this more before i do anything with that sensor.
as it would appear, the harness does only have one wire
it was also traced out in a chiltons manual to only have one wire
it was also traced out in a chiltons manual to only have one wire