oil pressure question and 1 other random question
CF Veteran
Joined: Jul 2009
Posts: 2,158
Likes: 11
From: Chico,ca
Year: 89
Model: Cherokee
Engine: 4.0
My oil pressure runs around 20 for the most part and 10 if it gets run hard,I use 20-50 and I am not concerned when it does get to 10.
As far as your rust,you can buy rust converter,I bought mine at wal-mart years ago. Call your local auto paint store and ask them,they should have something,it goes on light gray and actually turns black. It worked great for me.
As far as your rust,you can buy rust converter,I bought mine at wal-mart years ago. Call your local auto paint store and ask them,they should have something,it goes on light gray and actually turns black. It worked great for me.
"CF Moderator"
Joined: Sep 2008
Posts: 3,045
Likes: 3
From: N.J. Shore Area
Year: 1994
Model: Cherokee
Engine: l6 HO
When I was paying the bill for my a/c system work the mechanic came up to me and told me to watch my oil pressure that it was sitting a bar and a half from 0, well I told him that according to my haynes jeep manual the oil pressure should be around 13 psi at idle mine is around 10 psi at idle. My question is should I be concerned if my oil pressure is 10 psi at idle?
My random question is this my jeep spent three years on and off up north. So like 6 monthes in ohio and the other 6 monthes of the year here in n.c so it has light surface rust on the axles, I know I can just sand it down and paint over it but would any of you guys be concerned?, when I first bought it I was prety upset about the surface rust but now i've learned to just forget about it I figure I will go in later and sand and repaint the axles and replace the leaf springs.
My random question is this my jeep spent three years on and off up north. So like 6 monthes in ohio and the other 6 monthes of the year here in n.c so it has light surface rust on the axles, I know I can just sand it down and paint over it but would any of you guys be concerned?, when I first bought it I was prety upset about the surface rust but now i've learned to just forget about it I figure I will go in later and sand and repaint the axles and replace the leaf springs.
Thread Starter
Seasoned Member
Joined: Jul 2009
Posts: 279
Likes: 0
Year: 1998
Model: Cherokee
Engine: 4.0 inline 6
well the haynes jeep cherokee manual says that oil pressure should be 13 psi at idle, as far as the surface rust goes im probably gonna get por-15 and just sand and paint it with por-15. since I have to take it to a shop to get the fuel pump lockring replaced I will have the oil pressure sensor checked then. thanks for the input
Thread
Thread Starter
Forum
Replies
Last Post
MidwestNick
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
Feb 28, 2016 02:05 AM
CAT_Tech2
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
67
Sep 18, 2015 08:26 AM
riderjay253
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
Sep 16, 2015 11:31 AM
TNXJsleeper
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
Sep 2, 2015 05:31 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
