CF Veteran
PatHenry
CF Veteran
close
Jul 11, 2024
- Join DateNov 2017
- LocationGroton, MA
- Posts:3,700
- Year1995
- ModelCherokee(XJ)
- EngineI6 4.0L
-
Likes:206
-
Liked:238 Times in 211 Posts
I ordered MT90 from Amazon. I'm not familiar with the BA-10 tranny (so check out the fluid change procedure) but almost certainly you will want a fluid transfer pump.
Cruiser may be able to advise if MT90 (or in other words, low sulfer gear oil) is the recommended fluid for the BA-10. A quick Google search shows folks divided on GL3 gear oil (which MT90 would be good for) and Motor oil. (To be fair, when I looked into fluid recommendations for my AX15 there were people recommending motor oil for it.)
A critical point that needs to be said is that you need to verify the model transmission you have. The BA-10 has been a maligned transmission in Jeeps and a PO may have swapped it out for an AX15 or (unlikely but not impossibly) an NV3550.
CF Veteran
PatHenry
CF Veteran
close
Jul 11, 2024
- Join DateNov 2017
- LocationGroton, MA
- Posts:3,700
- Year1995
- ModelCherokee(XJ)
- EngineI6 4.0L
-
Likes:206
-
Liked:238 Times in 211 Posts
Or re-said as it were - Cruiser did mention you need to confirm the tranny model.
::CF Moderator::
cruiser54
::CF Moderator::
close
May 16, 2024
- Join DateAug 2011
- LocationPrescott, Az
- Posts:43,971
- Year1990
- ModelCherokee (XJ)
- Engine4.0
-
Likes:1,979
-
Liked:1,578 Times in 1,279 Posts
Quote:
What oil filter?Originally Posted by soehlked
Just finished the oil, went with 10-40 and some stabil. Also replaced the oil cap and now my pressure is stable at 30 psi idle and 35-40 while driving. Old oil was pitch black haha. Going to look more into trans this weekend. Anyone know where to buy the mt90 fluid? Autozone didn’t carry it and I’d rather buy it in person than online
CF Veteran
Quote:
First off, verify lube level and condition.
Identify which trans you have.
As with any "new to me" vehicle, check all fluids and condition right away.
Exactly at least if trans craps out it will have clean oil in motor for tow home Cruiser.Originally Posted by cruiser54
It amazes me how much info gets thrown into these threads without proper understanding of the situation. First off, verify lube level and condition.
Identify which trans you have.
As with any "new to me" vehicle, check all fluids and condition right away.
::CF Moderator::
cruiser54
::CF Moderator::
close
May 16, 2024
- Join DateAug 2011
- LocationPrescott, Az
- Posts:43,971
- Year1990
- ModelCherokee (XJ)
- Engine4.0
-
Likes:1,979
-
Liked:1,578 Times in 1,279 Posts
Quote:
LOL.Originally Posted by freegdr
Exactly at least if trans craps out it will have clean oil in motor for tow home Cruiser.