turbocherokee

I have a 95 Cherokee with a Dana 30 front axle. I keep blowing stock hubs and i would like to change the knuckles to 44 knuckles with locking hubs. Does anyone know if their are any companies out their that make a conversion?

rlevs

try this but you will have to add spacers in the rear to take you from 5 on 4 1/2 to 5 on 5 1/2.
http://rustysoffroad.com/mm5/merchan...egory_Code=AXL
but you are going to pay close to $1500.00

turbocherokee

i was looking at these http://www.reidracing.biz/DANA30.php

xjmarc

These work great but buy the time you spend the coin to get them in you could have gotten a different axle with lockouts. Warn also makes a conversion as well as Mile Marker but they are quite expensive.

turbocherokee

about how much will it cost?

xjmarc

Warn kit is 1300 bucks and the Mile Marker is about the same. The Reid knuckles are $260 each, plus spindles are $100+ each, rotors and hubs are $155 each, calipers and brackets $200+ each, outer stub shafts are about $150 a pair and locking hubs are $150 for a decent set. Plus brake pads, dust shields and other misc items. Like I said cheaper to swap out the axle. Doesn't make sense to put that kind of money into an axle that end the end is maxed out with 35s.

turbocherokee

505 performance runs 35s on dana 30 with over 500rwhp in their rock crawlers.

xjmarc

Not sure what that has to do with the topic but as long as they leave it in 2wd it'd be fine.
What exactly are you breaking/wearing out on yours?