Keyless Entry ?
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Location: Temecula,Ca.
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
Keyless Entry ?
Can you program the fob to unlock just the drivers door,no horn sound when locking,lights flash,etc.?I do not have the owners manual.Curently it locks the doors with a horn sound only,no light flash and unlocks the doors with no horn or headlight flash just the dome light.This is a 2000 sport 4 door.Thanx
#2
CF Veteran
Join Date: Aug 2010
Location: Canton, MI
Posts: 8,357
Likes: 0
Received 82 Likes
on
67 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
See if this works for you:
REMOTE KEYLESS ENTRY RECEIVER PROGRAMMING
The optional Remote Keyless Entry (RKE) system for this vehicle has a customer programmable horn chirp feature. The horn chirp is requested by the RKE receiver through a hard-wired circuit to the horn relay, whenever a valid Lock message is received from a programmed RKE radio transmitter.
The purpose of the horn chirp is to provide the vehicle operator with an audible verification that the Lock request has been received by the RKE receiver. However, for any number of reasons, some customers may prefer that this feature be disabled. This RKE system allows them that option.
To program the Remote Keyless Entry (RKE) receiver so that the horn chirp feature is disabled, proceed as follows:
(1) While within the reception range of the RKE receiver, press and hold the Lock button of a programmed RKE transmitter depressed for five to ten seconds.
(2) While holding the RKE transmitter Lock button depressed, press and release the RKE transmitter Unlock button.
(3) The RKE horn chirp feature is now disabled. Repeating the preceding steps will again enable the RKE horn chirp feature.
REMOTE KEYLESS ENTRY RECEIVER PROGRAMMING
The optional Remote Keyless Entry (RKE) system for this vehicle has a customer programmable horn chirp feature. The horn chirp is requested by the RKE receiver through a hard-wired circuit to the horn relay, whenever a valid Lock message is received from a programmed RKE radio transmitter.
The purpose of the horn chirp is to provide the vehicle operator with an audible verification that the Lock request has been received by the RKE receiver. However, for any number of reasons, some customers may prefer that this feature be disabled. This RKE system allows them that option.
To program the Remote Keyless Entry (RKE) receiver so that the horn chirp feature is disabled, proceed as follows:
(1) While within the reception range of the RKE receiver, press and hold the Lock button of a programmed RKE transmitter depressed for five to ten seconds.
(2) While holding the RKE transmitter Lock button depressed, press and release the RKE transmitter Unlock button.
(3) The RKE horn chirp feature is now disabled. Repeating the preceding steps will again enable the RKE horn chirp feature.
#4
Seasoned Member
Join Date: Jul 2013
Location: Groveland, CA
Posts: 426
Likes: 0
Received 8 Likes
on
8 Posts
Year: 1996 Two Door Wagoneer
Model: Cherokee
Engine: 4.0L
Converting to Newer RKE?
So CCKen,
How do I get a post 96 RKE to work on my 96 XJ? I think 96 was the last year of the infrared communication device. It would be real cool to use one of the spare fobs from my 02 Dakota to on the XJ. I grabbed an XJ RKE receiver from the ceiling of 2000 but could not figure a way to wire it up in my 96.
#5
CF Veteran
Join Date: Aug 2010
Location: Canton, MI
Posts: 8,357
Likes: 0
Received 82 Likes
on
67 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
I have used these sort of procedures on other vehicles to great success. Usually the owners manual will have that info. But not always.
So CCKen,
How do I get a post 96 RKE to work on my 96 XJ? I think 96 was the last year of the infrared communication device. It would be real cool to use one of the spare fobs from my 02 Dakota to on the XJ. I grabbed an XJ RKE receiver from the ceiling of 2000 but could not figure a way to wire it up in my 96.
So CCKen,
How do I get a post 96 RKE to work on my 96 XJ? I think 96 was the last year of the infrared communication device. It would be real cool to use one of the spare fobs from my 02 Dakota to on the XJ. I grabbed an XJ RKE receiver from the ceiling of 2000 but could not figure a way to wire it up in my 96.
#7
Trending Topics
#8
Seasoned Member
Join Date: Sep 2013
Location: LI, NY
Posts: 362
Likes: 0
Received 1 Like
on
1 Post
Year: 2000
Model: Cherokee
Engine: 4.0
For keyless entry help.
Please visit : http://programkeyfob.com/
Please visit : http://programkeyfob.com/
"Cherokee: There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote.
Please contact your dealer for programming."
Thread
Thread Starter
Forum
Replies
Last Post
Jooman07
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
01-03-2016 04:15 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)