ecm

 

id skin the wire to injector to expose about 1/4 of the wires to no 1 plug about a inch from plug and touch noid prongs to bare spots see if noid lights could be bad connection in plug ....start simple then progress to more costly fixs

 

plug is brand new an but i will check that just to be postive

 

new connections or just plastic

 

Complete pigtail from napa..still had the problem before i replaced this tho

 

Ok gotta find the injector ground at ecm plug check there ...

 

Check page 159..http://www.jeep4x4center.com/knowledge-base/index.htm

 

im lost at how to check that...lol not very good with wiring diagrams

 

Ok you computers mounted on your fender theres plugs on it your going to be looking for a white wire with a dark blue stripe on pin no 16 check that wire for ground when engines running

 

ok got ya il check that out tomorrow

 

Got my injector fixed...turned out it was the ecm...but now im stuck trying to figure out my next problem p0301...cylinder 1 misfire. Changed the plug an didnt worth..can i get some info on solutions for this...any ideas....ima swap the injector to #2 tomorrow see if the code follows