WonderBread

Here's the issue my gauges work except my Odometer, speedometer, gas gauge.
I've swap instrument clusters with similar ones at a junk yard multiple times just to see if there was a issue with the factory one I have but nothing seems to change I've cleaned the plugs on the back of the cluster, I've held the odometer while turning the key to ON it did the weird test all the gauges move left to right like their suppose to but whenever I start it those 3 still seem to not work any suggestions?

fb97xj1

I have read of others fixing that same issue by cleaning the battery terminals and nothing else. Try that.

PNWjeeper

http://cruiser54.com/

WonderBread

ive checked my grounds cleaned them
I've removed the gauge cluster cleaned the two Electric ports
cleaned my positive and negative terminals
ive done the test all the gauges move during the test but not after

freegdr

Found this


http://www.4wdmechanix.com/How-to-XJ...Gauges-Fix?r=1

WonderBread

I'll look into getting the part I wanna do a possible gauge swap to see if it's that what bothers me is my rpm battery and oil all work just not the speedometer odometer and gas gauge it's hard to believe all 3 went out at the same time

3278

Well, the speedo and the odo basically come from the same place, but yeah, it'd be weird for the fuel gauge to also go out at the same time.

freegdr

What year ?

CCKen

When you do the instrument cluster actuator test you're testing the software in the cluster, separate from any outside input, such as the CCD Bus, indicating there may be a fault in the cluster - but, as you said, you've tried different clusters and it didn't make a difference.


Are you sure the test was done properly?


Here's the test procedures and cluster gauges/lamps reaction points:



.

.