Any ideas why this is happening. It just started i just put new brakes on then when i went to drive it out of the shop bay it was idleing at 3000RPM. I did have to jump start it but i dont think that would cause it to do this. Any ideas?

 

tps?.....

 

should I just try cleaning it out?

 

check for vacuum leak(s)?

 

IAC
TPS
vac leak
dirty return spring throttle cable and connecting part

 

No vac leaks just looked. and the return spring is fine. It was running like a go cart last week it would barly stay running and now its running at 3000RPMs. So would that be the IAC or TPS?

 

you have to change the A.I.S. Automatic idle sensor,is next to TPS on the throttle body

 

AIS i have never even heard of that

 

I dont think its a sensor

it the IAC Idle Air Control it can stick and cause idle problems

 

hmmm i just cleaned it out too do you think i should replace it?

 

was this before or after you started having idle problems

they needto work very smooth or they wont work right

 

un plug it while its running and see if that changes the idle

 

k im going to go get one and take it in toamrrow but i will test my current one and see if it can be fixed or if its even the problem then if it cant i will replace it with the new one.

 

if you un plug it should make it idle very low or make it die

unless the valve it self is stuck then there would be no change

 

mine does this too but only when the A/C is running. when I switch the A/C off the RPM's drop.