So I was testing my o2 sensor today, and when I looked up, I seen a random wire dangling that wasn't plugged into anything. It goes into the wire loom over on the driverside where the computer and intake manifold it is near. Here are a few pictures.

note: it DOES NOT connect to the o2 sensor in the picutre with the wires cut off. Those are different exhaust manifolds from a later year that had them on it when I did an engine swap.

I am not getting any codes thrown which makes me believe it is just an unused connector, but i never noticed it dangling there before and didn't see anywhere for it to plug into.

Any help would be much appreciated!

from the top


the wire loom it goes into


looking up from under the jeep.

 

anyone?

 

Not sure if it's related, but read this;

I could be way off though.

http://www.naxja.org/forum/showthread.php?t=1095620

 

I know i don't have that sensor in that location, but maybe it is somewhere else on the brake booster. I'll have to give it a look.

I did an engine swap back in December, and don't remember seeing it then either. I guess ill check the brake booster area and where ever else it can reach too maybe tomorrow or on the weekend. I appreciate the link!

 

Ok do you have a abs vehicle? My 94 is not, and I have a two wire connector that plugs into a sensor on my brake distribution block below the master that seems to fit the location in your pictures

 

Nope, I have the 8.25 so no ABS. I'll take a look at the mentioned area tomorrow. Thank you for the info

 

I seen the connector that goes to the brake distribution block, that was plugged in. I've been swamped at work lately so I'll be taking a look this weekend. I'm starting to believe it's just an unused connector.