They call me cowboy

What is a SYE? every three days there is a new post or a old one drug up about it. Do I want one? Should I care? Will tacos be outlawed as they are as addictive as crack? Stay tuned.

Nor-CalJeeper

SYE ='s Slip Yoke Eliminator

It gets rid of the slip yoke on the transfer case so you dont get bad vibes after lifting your XJ over a certain height usually 4 to 4.5" +

89Laredo

SYE: Slip Yoke Eliminator

It gets rid of the factory slip yoke, which can cause Vibes after a lift. It is also much stronger

Since you are not lifted (or it doesnt list it in your specs) dont worry about it.

Tacos suck, burritos are better.

They call me cowboy

anyone have a pic, or a link to what I need to see? I Have 3" bastard lift,and2" lift coils from zj not going any higher. Going to be putting it in when I get some free time(never, children under 2= no time), just wanna have everything I need so I don't have to post"death wobble" or some variation.

They call me cowboy

WHERE'S MY BURRITO??!!!

89Laredo

I would do the lift, and if you get vibes do the SYE
Most the time they require a longer driveshaft to be made.

Im at 4" rear with no vibes.


Taco Bell...

newageoutlaw

Well I have a 6" lift with no sye and I am glad. haha well thats only cause the last trip I had I blew the rear U joint and just slid the drive shaft out and drove home.

89Laredo

It would be just as easy to pull out 4 bolts...

newageoutlaw

yes but on this trip I had no tools at all.

89Laredo

Usually when people go wheeling they take tools...

Joking, but take tools next time!


But really, My jeep has 3 tool boxes in the back, a roll of duct tape, a can of pb blaster, a can of liquid wrench, a tow strap, jumper cables, and a BFH in it at all times..

DagBMX

don't forget the hack'n'tap SYE!. essentially, does the same job as the full SYE kit, but requires cutting, drilling, and tapping of the shaft in the transfer case, and bolts a yolk to the shaft so it doesn't slip'n'slide like a stock one. then most guys will use a front CV drive shaft from a JY. many guys have used a hack'n'tap for years without problems, and others can't seem to do the work and have it last, so they replace with the kits. open debate, and i stand at it depends on how well you do the work which will make it last.

"my name is Jennifer Lopez. i like tacos and burritos. tacos flavored kisses for my Ben."



ok, back to topic...

spittinimage

No tools when you went out to play shame on you.