Alright guys. I need to know how to remove the plastic trim behind the window glass of a 2 door. I am guessing it just pops out but I don't wanna break it. This is what I need removed.



I have a leak coming from that area on the cubby side. It drips water through the top of the cubby plastic vent on top then leaks down the cubby into the floor. I am trying to track it down now since it's raining cats and dogs.

 

have you pulled pff the inner plastics to look for nuts yet? im not sure

 

Yeah there are none that I see. I will look again in a few. Its a constant drip and its driving me crazy.

 

Got it removed. Two little nuts. Didn't help me to track down the leak though. I can't see up in there far enough. Gonna hit the parts store and get one of those mirrors on a stick Gotta fix the leak. That is most always a Jeep's problem is leaks making them rot from the inside out.

 

Mine leaks due to the weather stripping around the tailgate is bad/messed up, dunno if that could be the cause of yours

edit: what about the roof rack leaking

 

Well I am checking it out now. It's not the roof rack. I can pour water in the valley where the hatch is and it starts leaking in. I am going to start sealing different spots until it stops. Gonna be a pain I think.

 

Seemed to be coming in around the Rubber grommet seal where the rear washer fluid goes into the hatch. I silicone'd it up real good and I will check it with some water when it cures up. Hope that does it. Got a lot of other work to get done.

 

Thousand words?

 

It was the rubber grommet for the rear wiper washer. I tested it with a ton of water and not one drip. Before I done it there was a stream almost. Woohoo, Glad that's over.