countryboy

ok, so the deal is that my IAT (air temp sensor) which is located on the intake manifold seems to be not working. i tested the wires and i'm not getting any electrical current through them, however my jeep seems to run just fine anyways. now i know this sensor is very important and regulates the air/fuel mixture, so how do i test it? p.s. i'm also hooking up a performance chip to it so i NEED to make sure it's working right. please help!!!!!!!!

tjwalker

Get a manual if you are going to be working on your Jeep. Factory service manuals are best, Chiltons and Haynes are just okay, but are generic in some instances and have been known to have a few errors. Should tell you how to test your sensors in those manuals.

Skip the chip. Search this forum and all other XJ forums and you will see that they are of little or no benefit.

ezab

TEST PROCEDURE

1. Disconnect the wire harness connector from the sensor.
2. Test the resistance of the sensor with a input impedance (digital) volt-ohmmeter.

1. Test the resistance of the wire harness.

TEMPERATURE
RESISTANCE (OHMS)
°C °F MIN MAX
-40 -4O 291,490 381,710
-20 -4 85,850 108,390
-10 14 49,250 61,430
0 32 29,330 35,990
10 50 17,990 21,810
20 68 11,370 13,610
25 77 9,120 10,880
30 86 7,370 8,750
40 104 4,900 5,750
50 122 3,330 3,880
60 14O 2,310 2,670
70 158 1,630 1,870
80 176 1,170 1,340
90 194 860 970
100 212 640 720
110 230 480 540
120 248 370 410