that other thread reminded me of something..

when i was doing my lift and unbolting the upper control arm i droped like a full set of sockets into my fram rail one at a time lmao i was soo pissed i kept dropping them in and couldnt get them out and soon there was a full set in there and then i relized that botl i have been tryin to get out wasnt even a bolt it was a stud haha im an idiot

lol ya so when i stop or acclerate now you can hear the sockets rolling around in there

anyone else do this? prolly not cuz im just dumb

 

if those are snap on and i see your jeep i will get out the portable torch and just cut the bottom out of your frame

 

i have a 15mm in my passenger side unibody i can see it and get a finger on it but the hole is to small to get it out of i get pissed when ever i see it

 

not yet but now that I posted I probly will next time I work on it

 

I have done that as well....SWEEET!!

 

what about one of them long magnets?

 

I tried that, but it just kept sticking to the inside of the unirail...FUN!!

 

mine went a little to far back and there is a divider in there so i cant get to it anymore but maybe it will fall out when wheeling or something

 

haha just an idea dang that would drive me nuts....

sorry dry humor there

 

I wonder if you could train a hamster to retrieve???

 

if you do mail him to me when you are done

 

dont cut out the bottom.... you can just cut a square of floor out and fish your hand or whatever in there. and not do that much damage

 

I dont' think even snap-on tools would be worth all of that work

 

jack one end up or drive up a steep ramp and see if you can get it to roll back to where it went in...

 

you seen a snap on price list? cutting out a little square, fishin a magnet in there and welding a patch on there isnt that much work