Front end shaking violently

Reply Subscribe

Thread Tools

Search this Thread

Jun 29, 2020 | 07:31 PM

#16

starrant

Thread Starter

Newbie

Joined: May 2020

Posts: 16

Likes: 0

From: Montana

Year: 1989

Model: Wagoneer (FSJ)

Engine: 4.0

I will look at the trackbar mount.

Jun 29, 2020 | 08:38 PM

#17

country2

Senior Member

Joined: Nov 2016

Posts: 807

Likes: 124

From: Homer Georgia

Year: 2000

Model: Cherokee

Engine: 4.0l

Quote:

Originally Posted by dave1123

That trackbar mount is enough to do it. The trick with that is to find or make washers that are a tight fit for the bolt, install the trackbar, then weld the washers to the mount. Tack them, remove the bar, then burn them! This ensures they are aligned before you weld them. Be sure to torque the bolts properly to prevent it happening again.

dang could of sworn I relied to you but guess I just thought about it....it bad getting old! Any way I was going to go that route but instead just drilled em out to next size up as it was not too bad. Although would be nice to use my welder more often that I bought for the floor pans replacement.

Jun 30, 2020 | 03:46 AM

#18

dave1123

Old fart with a wrench

Joined: Nov 2010

Posts: 14,398

Likes: 741

From: Manlius, east of Syracuse, NY

Year: 2000 XJ Sport & WJ Laredo

Model: Grand Cherokee (WJ)

Engine: 4.0L

How did you get larger bolts to pass thru the bushing sleeve? Oh, wait! I went back and read your post. So it was the ball stud end mount that was loose? I didn't think of that.

Last edited by dave1123; Jun 30, 2020 at 03:57 AM.

Jun 30, 2020 | 04:03 AM

#19