plowboy06

OK well i noticed a clunking noise in my front drive shaft today. I have a np207 tcase so it has the cv joint instead of the ujoint. I was wondering it there was anyway to convert the cv shaft to a ujoint shaft. I know the np231 had that style shaft and was wondering if the yokes would interchange. That way i could run the u joint shaft. Just thought I would ask. I dont want to put another cv in it because it will go out again soon.! Please let me know! thanks!

Jeep85

You can convert drive shafts.


$95.00 with good u joints Shipped

4.3L XJ

If I remember correctly, you will have to change out put flanges also. Make sure the length is right.

Jeep85

its a yuke

4.3L XJ

OK OK, needs to be changed anyway.

plowboy06

thanks for the help guys. Where can I get a yoke to put on the transfercase that will allow for the double ujoint style drive shaft. Thats my hold up. Will the 231 yoke fit my 207? splines same ect...

4.3L XJ

It has been awhile since I did it, but if memory seres me correctly I used a yoke off a 231

Eds73Lemans

not to thread hijack but, what vehicles come with that DS and yoke? i found a 93 zj in a yard and it had that DS lying in the back of it. does that mean it has a np231 with correct yoke??

trans_am7935

just use the yoke from a 231 and it should fit right up, but make sure you measure your transfer case to axle distance cause i am not sure if it is the same length.

plowboy06

yea i gotta good drive shaft guy here in town so thats not my biggest worry

plowboy06

guess im off to the jy to find a 231. Wish it wasn't so dang cold!