door hinges ?
#1
Newbie
Thread Starter
Join Date: Feb 2014
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
door hinges ?
need to replace my driver door hinge pins, the bushings are all worn and the door drops about an inch when its open, big pain in the butt to close, I have a new set that r suppose to fit my 01 Cherokee but the stock ones seem a little different. was wondering if any of you replaced these before, and how the old pins should be removed, I don't see a snap ring on them anywhere that would hold them in place like the new ones have
#4
Newbie
Thread Starter
Join Date: Feb 2014
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
thanks for the link, ended up removing the whole door, which means taking the panel off and unhooking the wires etc, . tried the air hammer to knock them out and nothing waste of time and money. used a 1 1/2" cutting wheel to cut the pins and wedged them out with ease. getting the hinge back in with the new bushings was a bit of a pain, tight fit, that's what she said lol, but it was a bonus having the door detached from the hinge i was able to wiggle it into position and slide the new pin in. note I had a issue with the new pins the teeth at the bottom wouldn't set/fit into the hinge, ended up using a hand file until I could hammer them into place. after that, bolted the door back up and adjusted to a perfect fit wasn't really too hard, just remove, cut, and replace. did it by myself just braced up the door with something
Thread
Thread Starter
Forum
Replies
Last Post
ZJBeachRunnerGC
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
18
03-10-2021 05:52 PM
cmcl3m0r3
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
05-21-2019 02:38 PM
Rambler65
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-29-2015 08:28 AM
Eli Brda
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-27-2015 04:13 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)