I tried replacing my dash lights with leds, but whenever I would put the bulbs in, they wouldn't work at all. Well I put the original bulbs back in, and those won't work at all either. The bulbs worked to begin with so that's not the issue. I even tried pulling a few bulbs that I hadn't even done anything with, and put them right back in, and still nothing. It doesn't seem to make any sense to me. Any thoughts would be greatly appreciated.

 

I had a similar issue after installing a new ignition switch now none of the dash lights are working. I still have not discovered the cause, so I'll be following this post

 

The LEDs' don't have the proper resistor and poped the fuse?

 

It's not a fuse. I only attempted a few bulbs and the bulbs that I didn't do anything with still work.

 

Is the printed circuit damaged?

 

Did the dash light work before you changed them out?

 

No damage and all of the lights worked before. It seriously makes no sense.

 

You might want to check the grounds for the lighting.

 

But would that be an issue when the lights I didn't do anything to still work?

 

Take a look at the contacts of the bulbs you pulled out, the LED's. If they look a little burnt, possible they burnt the contacts in the sockets. All I can think of considering the facts

 

That shouldn't be an issue with the few stock bulbs that I literally pulled out, and put right back in just to test what was going on. This is crazy.

 

Are you actually going to use a DMM to diagnose this or just argue with everyone trying to help you?

 

I'm not trying to argue. I'm just letting people know exactly what I've already done. A multi meter isn't a bad idea though.

 

I too recently replaced the ignition switch and now my dash lights don't work. I have tried the fuses, they are fine, head lamp switch is fine, because I tried a new one and it made no difference.