I had the hydrolic line for my clutch blow. Im hoping I can get the line from the clutch master cylinder to the connector outside the bell houseing. Its a 1991 Cherokee 4.0 ax-15. I got a picture

 

Try an auto parts store.

 

Advanced auto said they didn't have it

 

Try another? Or a dealership? Maybe RockAuto.com?

 

The dealers internet is down. Does anyone know what years are compatible for parts

 

Do you have an internal slave or external slave?

I believe 87-92 should have internal, 93+ external.

 

Thats gonna be a fun one to find ,.

 

I wish it were easier to go external.

 

Hardest parts staiyng up late watching e bay guys in cali post hours later beat every one to the deals

 

I'll just ***** out and go auto. :/

 

Well I mite have to have one made but does anyone know how to remove the hose from the master cylinder and slave cylinder. I assume the fitting on the side near the slave cylinder is how I remove that side but im not sure how to remove I have no idea on the master cylinder side of the hose

 

Is it plastic or metal and rubber...?

 

Cant tell in small pic ?

 

Had to fix mine a few years ago, here's what you'll need;
about 3 feet of high pressure hose(I used hydraulic steel braided) Quarter inch ID, make sure it's HP hose.
crimp on hose clamps.. got these at home depot where the PEX fittings are found. the ones you're looking for look like mini CV boot clamps(use bull nose pliers to tighten)
Cut the hard line close to the fitting end, slide the hose over and clamp(use two clamps about an inch apart on each end. You'll notice the clutch will take a little more effort. Mine's been like this for 3-4 yrs and no problems.

 

I think I know what your saying but do you have any pictures just to be sure