EEVEE

So im having a very annoying issue with my blower motor connector, It is plugged in all the way but i keep having to move it or poke it around to make it work. The wires on the plug going into the motor itself arent broken or loose but when i plug it in it doesnt work until i move the plug around. So i eventually zip tied it so it stays on but i wanna fix it. Very annoying when its cold and boop it turns off and need to open the hood and move it around till it works again.

PatHenry

Is it loose when connected or are the wires loose in the connector?

EEVEE

i can move the whole thing when its connected but if i keep pressure on any of the sides on the plug it will work perfectly fine. I can get a better idea of whats going on if i can see in there but its in a very hard spot to see.

peep

Although shape of your plug will be different, had same symptoms on my 89.
Yes frustrating.
Cut off the stock plug connections and about 1/4" of wire. Crimped individual male / female connectors onto the wires.
Connected. No more problems for the last 100K km.
Was bad wire connection within the stock plug.

PatHenry

Peep's advice sounds good.
​​​​​​​I was going to suggest putting some di-electric grease in the plug and then seeing if you can order a new plug or hit the JY for a replacement.