can someone re-assure me that 2.5" exhaust will fit on the cherokee... i want it run out the back from my new flowmaster 44 series muffler. except the last 3 shops i called said it won't work cuz there isn't enough room and its custom work which they will not do either...

pics would be cool too if you got them

 

I will reassure you . I have a full three inch all the way back. 2 1/2" will be even easier.

 

Thats what I'm running and no shop would work on it. They all told me it wouldn't work and that the flowmaster 40 im running is two short. my solution is a short male/female piece between the cat and muffler.

They wouldn't sell it if it didn't work.

http://rustysoffroad.com/mm5/merchan...y_Code=PER_EXH

 

I made my own. I used 3" bends from Summit Racing And cut and welded them together. However, there is an exhaust shop here locally that could make it for you . They do the custom stuff all the time.

My muffler is not a flowmaster, but about the same size, maybe a little shorter.

 

More than enough room you need to find another shop or as 4.3lxj said do it yourself

 

yeah the 2.5" will work, for some reason exhaust shops say they wont do it, probably because its not "stock." belive it or not i had meineke build me one and it was pretty good.

 

thx for the comments guys.... i got ahold of 2 other shops and they said the same thing.... custom work... can't do it.....
so i got one last shop to check out or else i found some 2.5" tail-pipes on ebay for $100 shipped and i may just go that route.....

keep the comments or pics coming guys about your 2.5" exhaust

 

i just got my new exhaust put in. 2.5 inches from the bottom of the header all the way back with a super 44. it sounds so sick. deep and throaty. only cost me $160. and i got it done at a shop...

 

its posiblle I am running the 2.5

 

i have a 2.5" cat, and 2.5" super 44 muffler with 2.5" piping. shop i went to welded it right up for me and made me the new tailpipe

 

plz inlcude where your from....
the shop i stopped at this morning gave some a BS run around how my cat is bad and they won't do the job unless i have a new cat... and offcourse they will supply one if i chose so... emmer effers the guy even started going into how my manifold was going bad also.... hmmmm.... convenient i guess i shoulda told him about my left handed muffler belt that might be bad also....

the guy also said that the materials would coast around $200 to do the job not including labor and a new cat.... etc...

 

i like the way mine sounds. i got a new cat online for $50 shipped.

 

Well I'm from good old Coos Bay, Oregon. I went to a local muffler/mechanic that's pretty well known. I bought my flowmaster super 44 offroad version muffler off ebay for $90. Then I paid $160 for all the 2.5 inch tubing from the header back. The $160 inculded taking old exhaust out, bending the exhaust tubing to get a custom fit and finally welding it all in. I'll go try and take some pics and post em if you want. I got it done last week so it's still shiny....

 

pics would be awesome

 

ill post some pics here in a lil bit by i assure you it will fit...i have a super 44 and magnaflow cat that are 2.5" inlet and outlet along with an IRO 2.5" tailpipe...jus give me a couple hours or so and ill post some pics for ya... if your wondering what it sounds like though heres a link: