T-bus
Sending you my Paypal address.

I bore them on a small lathe. I also blast the exterior, clean them well, grease the bearings and reassemble.
Im not sure there is enough meat to go to 64...but I do have a 62 mm that I did.
The only thing you have to do is find a 64mm throttle plate, and open the slot in the shaft. to accept the bigger plate.

 

I'm interested. Any Particularly noticeable differences?

 

Ive put most of the comments from my customers on this forum on a word doc. If anyone wants a copy without reading thru what is becoming one heck of a long thread......PM me your email address and I will send you a copy.

Thanks again to the 112 customers who have purchased these!!

 

Do u have any 96-91 TB done now, if so wats the price shipped to 63901

 

Im interested I have a 96 sp im in 33813 what would that shipping run? And where could I find the larger TB plate?

 

My bored TBs are now $80 shipped to anywhere in the US. $25 will be refunded upon returning a good core.

If you send one to me for boring, its now $55.

These are bored only below the plate to make it the same as the top, about 60mm. I also blast the exterior to make it look nice and clean & grease the bearings. You just add sensors, flash the ECU and drive.

I can bore the entire TB to 62mm but you must find your own throttle plate and modify the shaft to accept the larger plate.

 

send me your PayPal and I'll send you $80.00 for a bored TB.

wkentusa@innernet.net

 

Hey guys, I just installed the bored throttle body that I got from Dennis. Its great, lots more throttle response off the line. Ive recently pick up quite a few items from him and am very happy with everything. So if anyone needs parts let him know. thanks man
Now for injectors...

 

PM sent.

 

I will take one send me a paypal invoice or pm me thanks. whitenova69@hotmail.com

 

Money sent, thanks!

 

Payment sent. THANKS!

 

Dennis knows what he is doing. I plan on picking one up from him soon, as well as some other things we have been talking about.

 

i bored mine out myself polished the inside and installed new tps but not a iac installed and it idled high.. i took off battey ground but i didnot touch them together tried it again it idled smooth as glass but when i drive it at times it pops like it's out of time and bucks like it is misfiring when you get on it ... i took it off and put on my stocker took ground off ran it idles smooth runs out and pulls through all the gear fine i was wondering if the iac might be bad or something else i can't figure it out it did the same thing before the tps so i dk can you suggest something.. sorry for the high jacked thread but since you are doing them idk if you had ran into any problems like this...

 

I would clean the IAC very well first with TB cleaner. Then I would ground the Pos. cable to the block for 30 sec. Then reconnect the cable, turn on the key but dont start....turn on headlights, turn off lights....Done.