-So im about to start fabbing up the truss for my 30 which will be on the long side & connect both upper control arm mounts. My question is, "how do i weld on the truss without warping it OR melting the brand new seals inside??"
-I believe the way to do it is by welding 1 or 2 inch beads & then keep rotating all around & do only say 2 at a time & let them cool down till i start up again.

Simply put, how can i weld on the truss without warping a freshly built HP-d30 thats on the jeep & not melt the seals inside???

TKS

 

Short welds, and wrap the seal area with a wet towel, if you can. Otherwise remove the seals...I know thats a PITA.

Ron

 

I really DONT wanna gut the axle if possible!! Can it be done without that step??

 

Havin a hard time tryin to find pics of some homemade d30 trusses. Can anyone post up some pics or links so that i can get a few different ideas then the plan i have now??

Also, where should i weld & not weld to avoid melting the inner seals & components??

TKS!!