ok well i want to make some kind of intake for my 88 xj

where we take our rigs out around here there is alot of mud and water and it all gets into the air boxs

now i want some kinda intake for my jeep, but dont really want it sticking out from the side as much because it might get ripped off as this is my trail rig and its gonna get used

so any suggestions?

 

right up threw the hood pass side and the other is a pvc pipe on the side of the wind shield

 

search cowl snorkle

 

my buddy has a zj and he has some pvc that slides right over his throttle body and comes straight out the hood with a filter on it...doesnt do to bad but not really want i want

was thinking might run it along the windshield but not sure how to get it there w/o being in the way

 

cowl snorkel!!!

 

get a piece of flex pipe for that than a 90% angle pvc than shot a strait piece of pvc pipe along the ws to how long u want it than once set rtv it all together

 

thanks guys

i searched it earlier and found that

looks like i have yet another lil project for my jeep now...that should work just fine for what im gonna use my jeep for

 

ya that jeep is just a trail rig now not done yet just chopped the the back off it the other day and puttin the lift blocks in it to maro

 

no blocks!!! bad idea on xj leads to broken ubolt while drivin stock ubolt not strong enough an block allow the axle to move a lil bit!

 

got beefyer ubolts if just a trail rig but if u kno what ur talking about check my build thread i have ?s that need answers lol

 

yea...i posted on your "Build" thread, you may want to look what i wrote

 

Some PVC, a little RTV, a length of flex hose, 2 hose clamps and your done. 2 years, many water crossings, 0 hydrolocks....