Pre Bent Roll Cages.
#1
Member
Thread Starter
Join Date: Feb 2015
Location: Three Rivers Mi
Posts: 283
Likes: 0
Received 1 Like
on
1 Post
Year: 1999
Model: Cherokee
Engine: 4.0
Pre Bent Roll Cages.
So I'm in the market for a pre bent roll cage for my 97 4 door xj. I currently have a rock hard complete cage. But it's not installed. (From a previous rig). However looking into a pre bent setup. So I can make the new rig a complete trail rig. Any good ones? I'm looking at the d&c extreme cage Kit. Since I can't seem to locate the T&J Kit. Any reviews, or opinions is greatly appreciated.
#2
CF Veteran
Join Date: Apr 2012
Location: Dayton OH
Posts: 1,659
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0
I have the D&C extreme cage. I am very happy with it. The overall fit was great. I did have to do some minor tweaking, but a that could just be because my rigs been beat pretty hard. All in all it is a very good beginner cage. I do plan to add some things. Like a "c" pillar and some triangulation/gussetts. But even without all of that it is 100X better than no cage.
#4
Member
Thread Starter
Join Date: Feb 2015
Location: Three Rivers Mi
Posts: 283
Likes: 0
Received 1 Like
on
1 Post
Year: 1999
Model: Cherokee
Engine: 4.0
I have the D&C extreme cage. I am very happy with it. The overall fit was great. I did have to do some minor tweaking, but a that could just be because my rigs been beat pretty hard. All in all it is a very good beginner cage. I do plan to add some things. Like a "c" pillar and some triangulation/gussetts. But even without all of that it is 100X better than no cage.
#6
CF Veteran
Join Date: Apr 2012
Location: Dayton OH
Posts: 1,659
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0
Used a small ratchet strap to pull the 2 front tubes toward each other about 1/2" so that I could center them on the foot plates, it may actually be designed to mount on the edge of the plate in the front, for a little more leg room. But I wanted the feet centered. That was it. Other than that, it went perfect.
#7
CF Veteran
Join Date: Jan 2013
Location: west chester, pa
Posts: 19,216
Likes: 0
Received 39 Likes
on
35 Posts
Year: 1999
Engine: 4.0
Used a small ratchet strap to pull the 2 front tubes toward each other about 1/2" so that I could center them on the foot plates, it may actually be designed to mount on the edge of the plate in the front, for a little more leg room. But I wanted the feet centered. That was it. Other than that, it went perfect.
Trending Topics
#8
CF Veteran
Join Date: Apr 2012
Location: Dayton OH
Posts: 1,659
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)