-The Official Re-Gear Thread-
12-25-2011, 03:39 PM
#34
Seasoned Member
Thread Starter
Join Date: Dec 2011
Location: Texas
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L Inline 6
12-25-2011, 04:26 PM
#35
CF Veteran
Join Date: Dec 2010
Location: S.Jersey
Posts: 1,700
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
So what gears are in my front d30? Stock. I have an 8.25 rear. Also if I wanted to run 31's and 4.10's do. I put 4.10's in the front too? In other words does front and rear have matched gearing. I'm an auto aw4.
12-25-2011, 04:27 PM
#36
No. It's a low pinion axle that will require a lot modifications to install under a Cherokee. Not worth the time and money.
The Rubi d44 is a direct swap with no mods needed. not my favorite either...but you asked about an easy swap, and you can't any easier than this one.
Now if you want to install a beefier axle, the Ford HP (D44) with welded on wedges is the one you want. Narrowed down to GW width it's a great upgrade for strength and clearance. Not cheap, but it's the best D44 upgrade going.
The Rubi d44 is a direct swap with no mods needed. not my favorite either...but you asked about an easy swap, and you can't any easier than this one.
Now if you want to install a beefier axle, the Ford HP (D44) with welded on wedges is the one you want. Narrowed down to GW width it's a great upgrade for strength and clearance. Not cheap, but it's the best D44 upgrade going.
12-25-2011, 04:32 PM
#39
Seasoned Member
Thread Starter
Join Date: Dec 2011
Location: Texas
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L Inline 6
The 4.10s will be awesome with that tranny.
Thread
Thread Starter
Forum
Replies
Last Post
ROCKRIDGE 4WD
Vendor Showcase
13
11-05-2019 10:58 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)