Long arm set up
#1
Seasoned Member
Thread Starter
Join Date: Jul 2012
Location: sacramento
Posts: 274
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 ho
Long arm set up
ok so im waiting for my long arm kit ima trying out the dirt bound mid arm kit with dual uppers its a diy kit so i can make my arms any length my question is wats the best way to get the axle centered an extended out? im running ima say 5.5 in lift my thoghts were to make jack stands for ride height then take the coils out an move the axle as needed bout then wont know when the coil is strieght so anyone that has done a diy or bilt yor own long arm kit advice is nice thanks 
#2
CF Veteran
Join Date: Oct 2009
Location: somewhere Gee oh Dee cant find me...
Posts: 4,529
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: I6 4.0L
how far forward do you want to move the front axle? cuz i really dont think you can go very far without screwing with the driveshaft, coils, brake lines, and steering components.
#4
Old School CF Moderator
Join Date: May 2010
Location: Chattanooga
Posts: 9,652
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
Measure from the point of the arm mount to where you want the center of your hub to be. if you want to stretch add an inch or so.
Im stretched in the front about 2 inches. No negative affects.
Im stretched in the front about 2 inches. No negative affects.
#5
make those arms as long as you can. mid arm setups shouldn't be radius arms. tons of caster change and more binding than a long arm setup. as for figuring out axle placement, I have never had an issue by simply measuring. you can also hang a string with a washer tied to end from the bumpstop towers and line them up with the coil buckets.
#6
Seasoned Member
Thread Starter
Join Date: Jul 2012
Location: sacramento
Posts: 274
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 ho
make those arms as long as you can. mid arm setups shouldn't be radius arms. tons of caster change and more binding than a long arm setup. as for figuring out axle placement, I have never had an issue by simply measuring. you can also hang a string with a washer tied to end from the bumpstop towers and line them up with the coil buckets.
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
JPXJMOAB
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
09-06-2015 07:16 PM
shotseven
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-06-2015 03:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)