s346k

we're any of these problems present before the conversion?

mnewxcv

go back to the sealed beams to rule out new lights.

JPXJMOAB

no, only after. But I did not do the harness upgrade yet.

JPXJMOAB

or not. The sealed beams are terrible. And the lamp isn't the issue, my blinkers no longer work either.

salad

Did you find out if the 12V was coming from the vehicle or a problem with the harness?

JPXJMOAB

yes I have 12v from the harness

salad

With the lights all turned to off? Sounds like a switch be broken

JPXJMOAB

I don't remember to be honest if lights were off.. I'll have to check again tomorrow. I was in a hurry today. I'll post up tomorrow to be specific

JPXJMOAB

however, which switch would it be in that case?

salad

Since turn signals are impacted I'd be looking at the multifunction switch first

JPXJMOAB

alright. I planned on getting one tomorrow. You think that's more than likely my problem?

salad

I think it'd be a good thing to test lol. It's very conicidental that everything was fine BEFORE you did work... I don't like throwing parts at things. Very expensive way to troubleshoot.

mnewxcv

id at least try disconnecting one light at a time. the short could be in the filaments for lo and high (as in if they are shorted, the low beam could be energizing the high beam filament (circuit)). good luck hope its the switch and is a quick fix.