hallenbecks

today i was going down the road and all my gauges stopped working but temp and fuel, i stopped recalibrated all the gauges started it back up worked for like 30 secounds then everything died again and it says no bus. anyone have this problem?

zman32006

Year xj? Motor? Etc... have you traced the wiring?

Roughcherokee95

i am having the same problem too, and my gauges don't work at all.
this has happened to me before, and it was the fuse 17 or 15, under the hood.
& i have checked again. those fuses aren't blow.. so i am lost just like you!

hallenbecks

its an 01 cherokee with the 4.0 and no it just did it today ive heard it can be anything from connection behind cluster, sensors on tranny or rearend, tcm,pcm, bad ground so idk where to even start.

zman32006

Yeah I'm used to a 90 and a 96 so I'm of no help with an 01 but yeah id say a connection or a ground, id start with wiring

Roughcherokee95

I have a 97, and i was told it could be the senor off the transmission, the crank shaft position senor.. i changed it, a 80 dollar part. still NOTHING /:

zman32006

Ive never heard of the CPS causing dash problems, only spark problems.

Roughcherokee95

Main man jon at 4wp here in Raliegh NC, had to change his.. and it caused him dash problems..

but this may be the most obvious thing, i was stumped on my gaiges today..
i went and got new sparks, thermostat and stuff & after changing the the jeep didn't start. i had to get my battery charged, after getting it charged my gaiges work again so maybe disconnect the battery and see what happens.