jshultz78

Is there anyone here that has the rough country bumper with the bull bar that has the 3 light tabs? I need a measurement, the inside width of the bullbar where it mounts to the bumper, I want one of these to put on my goliath bumper, but I'm not sure it'll be wide enough to clear the valley the winch sits in.

Martlor13

I will grab a measurement when i get home

jshultz78

You ever make it home? haha

Martlor13

nope!! On work travel right now lol i will though today, i fly in this evening

jshultz78

Martlor13

from its shortest point, its about 27.5 inches...i had to eyeball it a bit as my winch is in the way but give or take a quarter inch from that.

jshultz78

WEll damn, that won't work, the narrowest it can be is 29" that's the measurement I have on mine from where the flats drop into the valley for the winch, it would have 1" overhang and look goofy.

Martlor13

Rough country also has one for the jk that looks like it could be wider, but i have no clue on that.

jshultz78

I ordered 2 different smittybilt ones from work today, If one fits I'll prob run with that, if not I can just send them back. But the holes in the fairlead are pretty convenient if you ask me. lol

jshultz78

Went with the smittybilt bar, Not as tall as I wanted, but gives decent protection of the winch, and if I ever wanted to go the stinger route, the bolt holes are the same. Surprisingly this whole setup only dropped the front 1/2" from a no bumper at all measurement, I've still got a set of 3/4" spacers I can stick back in if it wants to settle anymore though.

RockinRonnie

I also just installed the smittybilt bar on to my non smitty bumper and agree wanted a little taller but will work for some protection for the new wonch!

jshultz78

Decided to change it up a bit.